11/18/2023 0 Comments Drywall over lath and plaster![]() Then you will finally see the lath behind this plaster. Grab a crowbar or any hammer and start tapping the area until you create a hole, do this repeatedly until you see the lath beneath. ![]() The center of the topmost section will be your best spot for starting your work. If there are any decorative kinds of stuff on the wall, keep them safe aside. As well as a dumpster that certainly will hold all the harmful dust and debris generated. This task is guaranteed to be messy, so you will get a lot of help from garbage cans that are present in the workspace to make cleanup a lot easier. Locate the supply lines that run along the walls and carefully do the job around them. So, turning off the power and water supply will be a safe option before starting the main process. While hammering, you might accidentally damage and cause even more problems to the lines. There is a possibility that this might happen immediately once you switch on your HVAC system. This is necessary because lead and asbestos dust can settle inside these vents without you noticing and can affect your health. Next is covering up vents, air ducts, and other openings to prevent dust from entering. You can cover your floor with plywood because they are best at protecting from damages. The floors and entryways must be covered up with sheets to avoid getting damaged and also to limit the mess if possible. Use cover sheetsĮither transfer all furniture from the present room or if it is not possible then covering them up with plastic sheets may do. So, you have to be methodical about it due to the safety risks involved, and so much more. And smashing everything with a hammer is certainly not your option. Or you can just get rid of the lath and make room for the new wall. If we decide to use the existing lath then that must be in good condition to support the panels that are going to be installed on it. Once all the safety measures are in place and the prep works are completed, that is your start mark for removing the plaster on the walls. Prep work before removing the plastersĪ few quick points you need to check before starting the job. However, an asbestos mask will work best, especially one that can also protect the wearer from any kind of lead exposure. Wearing safety gear like safety goggles, earplugs, work clothes that can entirely cover up the body, and a face mask. Safety measurementsĪnyone who will be involved in plaster removal must always follow basic safety measures and preparations, such as: Then, after taking all the prep works you can start installing new drywall on the lath. As we know, the lath provides a solid, stable foundation for the drywall boards. The lath nailed directly to the wall studs, supports the plaster wall coat.Īfter you have removed the plaster, you can ignore shaping the lath in place if you wish. Behind the plaster walls are one kind of narrow strip of wood called lath. Removing plaster walls and replacing them with drywall is not a difficult job but a messy job.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |